18-12-2025

Certification of pile systems DPA and DPA-PLUS

Vroom Funderingstechnieken and Van ‘t Hek have jointly certified the pile systems DPA and DPA-PLUS with a self-declaration in accordance with NPR 7201.

This process took over two years and involved load tests in which test piles, equipped with extensometers, were loaded to failure. In addition, an expert committee appointed by the Netherlands Standardization Institute assessed both the installation of the piles and the test results.

Multiple load tests were carried out during the process to accurately determine the shaft resistance and base resistance of both pile systems. The piles were subsequently extracted and analysed. This investigation was conducted in cooperation with the expert committee from NEN and an independent specialist. The resulting pile class factors for shaft and base were recorded in a self-declaration. These pile class factors and corresponding pile diameters replace the αp and αs values from table 7c of NEN 9997. From 20-03-2025 onwards, the self-declaration must be used for the design of DPA and DPA-PLUS piles.

The findings align with the expectations of both companies. The determined pile shaft resistance proves to be higher than previously stated in the standard. This contributes to improved application of the pile systems and offers new possibilities for foundation design.

The text continues below the photos.

With this certification, Vroom Funderingstechnieken and Van ‘t Hek Groep strengthen their position in foundation technology and contribute to further innovation and reliability within the sector.

With our 3D animations of DPA screw piles and DPA-PLUS screw piles, we demonstrate the technique and application possibilities both above and below ground in approximately two minutes.

DPA screw piles
DPA-PLUS screw piles

For more information on the certification and quality marks for foundation piles, visit the NEN website.

The pile class factors have been determined using a nationally applicable Type A1 self-declaration, which has been documented in a report that can be viewed and downloaded here.

For advice on the application of these pile systems, please contact us via the contact form or by phone at +31 (0) 299 409 500.

Share article:

More posts

Solid and sustainable foundation for factory expansion
17-09-2026

Solid and sustainable foundation for factory expansion

Vroom Funderingstechnieken has completed the foundation works for the expansion of a factory in Groningen. This expansion represents a substantial investment in a future-proof production facility, with a strong focus on climate and environmental improvements. For the foundation works, Vroom installed DPA-combi screw piles using the Hillcon HSCX700GLS. In addition […]
Concrete construction and reinforcement steel now under one organization
11-09-2026

Concrete construction and reinforcement steel now under one organization

As of 10 September 2026, Beton- en Vlechtbedrijf Hadek B.V. (“Hadek”), part of the Vroom Group, has acquired Bekkers Beton- & Timmerwerkzaamheden B.V. (“Bekkers”). With this strategic step, Hadek expands its services and further strengthens its position as a partner for both concrete construction and reinforcement steel. Hadek has a […]
Vroom Groep and suppliers support Stichting Ambulance Wens
09-09-2026

Vroom Groep and suppliers support Stichting Ambulance Wens

At Vroom, we believe that technology goes beyond simply delivering projects. Sometimes, a project also provides an opportunity to give something back to society. A fine example is the foundation project at Ambachtsweg in Rhoon for Stichting Ambulance Wens, carried out by VDB Funderingstechnieken. By joining forces with a number […]
To top